Skip to main content

MTB Design (PART_02) FRONT FORK DESIGN IN NX

A mountain bike (MTB) or mountain bicycle is a bicycle designed for off-road cycling.


Comments

Post a Comment

Popular posts from this blog

Introduction

Hello everyone, Welcome to  Be Creative In this website you will find TUTORIALS, MECHANISMS, AUTOMATION, ROBOTICS & Much more . Here you can find Videos in SOLIDWORKS, SIEMENS UNIGRAPHICS/NX, PTC CREO, CATIA etc. The tools those are covered in Our Videos are Part & Assembly modelling, Mold design, Sheet metal, Motion analysis and much more.           You can connect with us by following us. so you will get the notification for all upcoming posts. Thanks for giving us your valuable time.
Post a Comment
Read more

AIRCRAFT ENGINE Animation in UNIGRAPHICS

One piston, the uppermost one in the  animation , has a master rod with a direct attachment to the crankshaft. The remaining pistons pin their connecting rods' attachments to rings around the edge of the master rod. ... The  radial engine  normally uses fewer cam lobes than other types
Post a Comment
Read more

Geneva Mechanism

Geneva Mechanisms  are widely used in motion picture  film  projectors to intermittently advance  film  through a  film  gate having a projection aperture. The  film  is moved or advanced by a  Geneva Mechanism  (also known as a “Maltese Cross”) until an image frame is in alignment with the projection aperture. In  watches , the " drive "  wheel  is the one that winds up the spring, and the  Geneva wheel  with four or five spokes and one closed slot prevents overwinding (and also complete unwinding) of the spring. ... The Iron Ring Clock uses a  Geneva mechanism  to provide intermittent motion to one of its rings.
Post a Comment
Read more