Piston Design using NX

The functions of the pistons are  to transmit the gas forces via the connecting rod to the crank shaft,  to seal - in conjunction with the piston rings - the combustion chamber against gas leakage to the crankcase and to prevent the infiltration of oil from the crankcase into the combustion chamber,  to dissipate

Comments

Introduction

Hello everyone, Welcome to Be Creative In this website you will find TUTORIALS, MECHANISMS, AUTOMATION, ROBOTICS & Much more . Here you can find Videos in SOLIDWORKS, SIEMENS UNIGRAPHICS/NX, PTC CREO, CATIA etc. The tools those are covered in Our Videos are Part & Assembly modelling, Mold design, Sheet metal, Motion analysis and much more. You can connect with us by following us. so you will get the notification for all upcoming posts. Thanks for giving us your valuable time.

AIRCRAFT ENGINE Animation in UNIGRAPHICS

One piston, the uppermost one in the animation , has a master rod with a direct attachment to the crankshaft. The remaining pistons pin their connecting rods' attachments to rings around the edge of the master rod. ... The radial engine normally uses fewer cam lobes than other types

Geneva Mechanism

Geneva Mechanisms are widely used in motion picture film projectors to intermittently advance film through a film gate having a projection aperture. The film is moved or advanced by a Geneva Mechanism (also known as a “Maltese Cross”) until an image frame is in alignment with the projection aperture. In watches , the " drive " wheel is the one that winds up the spring, and the Geneva wheel with four or five spokes and one closed slot prevents overwinding (and also complete unwinding) of the spring. ... The Iron Ring Clock uses a Geneva mechanism to provide intermittent motion to one of its rings.

Search This Blog